48 inch bench cushion – Finishing the corners on upholstered bench cushion is a common treatment for box-type dampers. Usually, the corners are finished with edging. Welting is wrapped fabric recording that is inserted into the horizontal seams that form the top corners of the bench pad. The use of a welting finish will make the bench look more elegant and formal, and the sides of the pad will be more vertical facing curved. Adding welting requires a lot of attention to detail, but it is not physically difficult.
How to finish the corners of an upholstered 48 inch bench cushion. Spray the top of the wooden bench with spray glue and position the foam 4 inches thick centered on the bench, so that it is larger than the bench seat. Trim around the outside of the foam using an electric knife. Keep the knife straight so that the cuts are sharp.
12 Picture Gallery: Ideas Upholstered 48 Inch Bench Cushion
Then for finish the corners of an upholstered 48 inch bench cushion, batting Duvet 2 Cut double the length and width of the foam. Place the flat part of batting on the work table. Turn the bench upside down and center the foam on the batting. Pull the top center of the batting to the bottom of the bench and staple 2 inches from the edge. Pull the bottom part of the bottom and staple, then the left and right sides. Continue using this pattern from the center outwards. Fit around your legs. The excess is removed.
This post topic: Cushion Designs